STI Alert Point, Руководство по установке и Руководство пользователя

Страница: 12 / 20

-12-
Installing External Strobes / Beacons
Step 1. Ensure that the unit is switched ‘OFF’.
Step 2. Insert the external strobe/beacon wires into the correct terminals.
Step 3. DIL switch SW6 – should be ‘OFF’ (external sounder(s)/strobes(s) to trigger
during alarm condition).
Important: Please ensure all external strobe(s)/beacon(s) have their own power source and are
wired correctly in accordance with their own installation manuals.
Warning: Incorrectly installed external devices may cause irreversible damage to the Alert Point.
Step 4. Turn the unit ‘ON’ using the master key switch.
Step 5. The LED will flash green every 8 seconds (or will remain constant if connected
to an external power supply), this indicates that the unit is functioning correctly.
Step 6.
Test: When the operating element is depressed, the unit will go into alarm
condition: the externally installed strobe(s)/beacon(s) should now flash.
Step 7. Reset the Alert Point using the reset key, all strobe(s)/beacon(s) should now
cease flashing.
Please note:
If the ‘Auto Reset’ is disabled (DIL switch SW11 ‘OFF’) the strobe(s)/beacon(s)
will continue to flash until the master key switch is turned ‘Off’. When turned back
‘On’ the unit should be in ‘standby’ condition.
Optional Internal Beacon
An optional extra (not supplied as standard) for the Alert Point is the capacity to
incorporate an internal beacon – this can provide for those who may be audibly
impaired.
Note:
All external sounders must be hard-
wired using 2-core cable, and must
have their own power supply. It is
recommended that external wiring
does not exceed 50 metres.
External Strobe /
External Strobe / Beacon -
Need technical support? Call us on +44 (0)1527 520 999