ci-405
Page 2 of 4
REV 000
a
2002 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: [email protected] Phone: 1-716-662-2680 Fax: 1-800-685-1122
Made in U.S.A.
through the metal frame as close to the chosen location as possible. Be careful not to go
through the insulation in order to better conceal the base of the antenna.
Using a sharp knife cut a small slit or X over the top of the drilled hole to allow the top of the
base to protrude.
2. Install the magnetic antenna base from the underside of the deck. See figure 3 below.
Figure 3
3. The magnet is designed to hold the base in place while 2 sheet metal screws are installed as
close to the magnet as possible to secure the assembly to the frame. See figure 4 below.
* Caution: Cabling must have strain relief support to prevent damage to connector.
Figure 4
4. From the top of the deck carefully thread the spring assembly onto the protruding base. Screw
the tuning mast onto the spring assembly.
Drill hole through here.
Install 2 sheet metal screws
as close to magnet as
possible.
