19
03/13424999489
SHE chain motor CM EasyDrive/2
Mounting
The installation of chain motors dependents on the opening type and the profile system of the window.
Therefore the mounting set have to be ordered separately.
These mounting set including:
- 2 Swivel bracket,
- 1 Hinge brackets,
- 3 Pins inclusive spring band,
- Screws and clinch nut,
- An assembly blueprint, adapted to the mounting situation.
Attention
: The permissible ambient temperatures are to be taken into consideration when choosing the
installation site.
Attention
: The profile situation and profile strength must guarantee that in case of motor failure the window
casement will not twist and thus cause the glass to break. In case of doubt we recommend that this should be
tested.
Electrical connection
Installation by electrician to avoid damages on the chain motor!
Mount power cable
Loosen the screw and remove the cap from
the drive housing
Punch the grommet and perform connecting
cable. Cable length from the grommet to
socket connector 120 mm.
Connect the power cable with socket
connector (see connect power cable).
Screw the power cable with strain relief and
the cap.
Connect the socket connector with below
connector on the board in the drive
Screw the cap again with the drive housing.
Pin assignment when using a power cable from STG BEIKIRCH:
wire color wire profil
1: 24 V 0 V
white
0,75 mm²
2: 0 V 24 V
brown 0,75 mm²
3: Bus A
green 0,25 mm²
4: Bus B
yellow 0,25 mm²
5: signal contact grey
0,25 mm²
6: signal contact pink
0,25 mm²
srew
2
3
4
5
6
1
power cable
drive housing
strain relief
socket connector
below connector
on the board
grommet
cap
