stex S25R, Руководство по обслуживанию

Страница: 30 / 37

< 30 >
4) Position the REAR COVER(11) at the back of the DISPLAY CONSOLE and secure it using four M5

10mm
TAPPING SCREWS(12).
7. Assembly the RECUMBENT SEAT ASSEMBLY.
1) Position the SIDE HANDLEBAR(13) as shown.
2) Connect the HEART RATE CABLE(h) leading from the
SIDE HANDLEBAR to its respective location in the bottom of
SEAT FRAME(B).
3) Secure the SIDE HANDLEBAR using three M8

20mm
SCREWS(14).
Note: Tighten the SCREWS securely.
4) The other side both work on the same method, 1) ~ 3).
8. ASSEMBLE the RECUMBENT SEAT ASSEMBLY(C).
1) Position the RECUMBENT SEAT ASSEMBLY(C) near the
rear of the LM GUIDE(D, AL extrusion) as shown.
2) Slide the RECUMBENT SEAT ASSEMBLY down as shown
until you can connect the flat-flex cable
(
i
)
as shown.
3) Connect the flat-flex cable securely as shown.
Note: Be careful not to twist the cable.
4) Slide the RECUMENT SEAT ASSEMBLY down adequately
until it rests.
Note: If the RECUMBENT SEAT ASSEMBLY rolls from side to side, reassemble the three UPPER ROLLER
ASSEMBLIES.
- Unfasten the three M8

15mm SCREWS.
- Using a spanner, turn the hex bolts of UPPER ROLLER ASSEMBLY
(
E
)
clockwise or
counterclockwise until the UPPER ROLLER are contacted with the way inner upper of
LM GUIDE(ALUMINUM EXTRUSION).
- Fasten the bolts of UPPER ROLLER ASSEMBLIES securely.
- The other side both work on the same method.