StewMac 57 MINI TWEED, Руководство по сборке

Страница: 17 / 40

stewmac.com
15
© 2018 StewMac
STEP 29
Output transformer blue lead
Trim the blue wire from the output
transformer to a suitable length and
wrap it onto pin 3 of the 6V6 socket .
Don’t solder this connection yet .
STEP 30
Output transformer yellow lead
Trim the yellow wire from the output
transformer to an appropriate length
and wrap it onto the center lug of the
speaker output jack .
5Y3 6V6 12AX7 SPEAKER JACK
JACK 1 VOLUME POT LAMP FUSE JACK 2
4
3
2
1
8
7
6
5
6
4 3 2
1
9 8
7
5
4
3
2
1
8
7
6
5
STEP 31
Ground the volume pot
Cut a 3" piece of green wire and solder
it to the left lug of the volume pot as
pictured .
Wrap and solder the other end of this
wire to the three-lug grounding strip
near the pilot lamp .
A wire between two parts like this is
called a jumper . Don’t cut this piece
too long, because there’s just enough
green wire to create all the jumpers
you’re going to need .
STEP 32
Inspect and double-check
This is a good time to step away from
the project for a few minutes and take
a break .
When you’re ready
to go at it again,
carefully review
every connection
you’ve made so far .
When everything
checks out, you're ready to move on
to the eyelet board .
Be suspicious
Assume there's
a mistake and
you’re the one
who’ll find it!