Stewart Audio Gemini, Руководство пользователя

Страница: 5 / 18

Gemini 5
PREPARING THE INSTALLATION
Before proceeding with the installation of this screen, take time to thoroughly read and understand
these installation instructions
INSTALLATION
The Gemini projection screen is ready to install when first removed from its shipping crate Remove
outer paper that surrounds the housing You will notice that there are (4) mounting holes located at the
upper corners of the housing You can use All Thread, lag screws, chain or other hardware fasteners as
necessary to secure the Gemini to the sub structure
Professional mounting techniques and appropriate rated hardware must be used to secure the Gemini
screen to its mounting location Stewart Filmscreen cannot be held liable for faulty or sub-standard
installation practices
Ensure that the housing is level and plumb once secured / mounted The screens must be level for normal
/ best operation
After the Gemini is installed, make sure to remove any remaining packing materials or batten retaining
clamps Failure to do this will cause screen failure during first time activation
ELECTRICAL CONNECTIONS
The Gemini control system can be accessed by removing the hex nuts that secure it to the electrical
internal end of the Gemini Alternate connectivity provisions can be made or altered as needed See
photo on next page for controller access
Perform all necessary switch wiring connections before power is applied to the control box The supplied
AC power cord can be plugged into a standard AC outlet or the cord’s plug can be removed and then the
power cable can be hard wired directly into a J-box
Connect the dual channel keypad to Port 0 on the screen board and trigger cable (if required) to the
controller’s low voltage switching input Also at this time make any other necessary connections as
required These could be third party or serial control connections