12
2.6 Network Connector
An RJ-45 connector is provided on Dante network enabled models.
Connect this port to your audio transport network switch or router (see
Section 3.4 Dante). Network and cable requirements are available from
the Audinate web site at
www.audinate.com
.
All network-enabled DSP100 Series amplifiers are shipped from the
factory with
network
input 1 routed to
local
output 1 (via the internal
DSP software mixer). The DSP100-2 model is shipped with network
input 2 routed to local output 2. This can be changed as desired via the
DSP Control Center software.
13
DSP100-1
DSP100-2
DSP100-1-D
DSP100-2-D
Output Power per
Channel
100W @
70/100V
100W @
70/100V
100W @
70/100V
100W @
70/100V
No. local Inputs
2 balanced
No. local Outputs
1
2
1
2
No. Network
Inputs / Outputs
0/0
2 /0
3 Operation
3.1 Operating Precautions
1. Before use, your amplifier must be configured for proper operation,
including input and output wiring hookup. Improper wiring can re-
sult in damage to equipment or potentially harm to the operator.
Consult Section 2 for setup instructions.
2. Tampering with the circuitry, or making unauthorized changes is
not only dangerous but may also violate local regulations.
3. Use care when making connections between the amplifier and the
input or output equipment. Using equipment that is not capable of
handling the output wattage may lead to permanent damage.
NOTE: Stewart Audio will not be held responsible for
damage to your DSP100 Series amplifier or connected
equipment if the instructions in this manual are not fol-
lowed.
3.2 Model Configurations
The basic differences between the DSP100 models are outlined in the
table below.
