6
2 Setup
2.1 Setup Precautions
CAUTION: Before installing your amplifier, make sure that
you have read the Important Safety Precautions at the be-
ginning of this manual.
2.2 Amplifier Installation
Two rack mounting options are available for the DSP100 Series amplifi-
ers. A single rack-mount kit provides for installation of a single DSP100
Series amplifier on a 1RU rack. The dual rack-mount kit provides for
the installation of two DSP100 Series amplifiers side-by-side on a single
rack.
2.2.1 Single Rack Mount Kit (Part Number RMK-HLF-S)
Assembling the single rack mount kit is straightforward. Attach each of
the right-angle brackets by inserting the 2 screws through the bracket
into the side of the FLX enclosure. Two straight brackets are also pro-
vided for the rear of the amplifier. The method of attaching these to
the rack will depend on the type of rack you are using.
2.2.2 Dual Rack Mount Kit (Part Number RMK-HLF-D)
Refer to the figure on the following page when assembling the dual
rack mount brackets onto the FLX amplifier.
Step 1:
Note the position of the captive nuts on the inner brackets.
One set must be near the front of one amplifier and the other set near
the rear of one amplifier.
Step 2:
Attach the right-angle brackets to the front of each amplifier
and the flat brackets to the rear of each amplifier.
Step 3:
Attach inner brackets to each amplifier
as oriented in step 1
.
the front of the pair of inner brackets and two screws to the rear pair of
the inner brackets.
7
Step 4:
Bring the two subassemblies together, overlapping the flanges
on the inner brackets. Complete assembly by inserting two screws into
the front of the pair of inner brackets and two screws to the rear pair of
the inner brackets.
CAUTION: Use only the screws provided in mounting
brackets to the amplifier. Do not over tighten.
