Final Assembly Continued
☐
Mount rudder servo using hardware supplied
by servo manufacture. Temporarily connect
servo to radio and center electronically.
☐
Set the motor mount in position on top of the
hull assembly then fit the completed C1 and
C2 plywood rudder mount and control horn to
rudder and post as illustrated below with
control horn on same side as the servo.
☐
Assemble the Park 250 [SUPA1510-15]
motor with cruciform back plate and set screw
prop adapter [EFLA1927] as illustrated below.
☐
Insert the motor leads from the ESC through
the motor mount and connect to the motor.
☐
Mount motor to motor mount using four
provided #2 x 1/4 in. screws. Place two #4
nylon washers between the cruciform mount
and the motor mount to shim the right side of
the motor (when viewed from stern of boat).
☐
Thread ESC motor supply leads and servo
wire through hole between
front
and
rear
hatch as illustrated.
Build Instructions
© 2013 Stevens AeroModel all rights reserved.
Page 17 of 25
C1
C2
Control Horn
Servo
EFLA1927
SUPA1510-15
Left
Right
#4 Nylon Washer (Right Side Only)
SAME SIDE
Tip: Waterproof the motor/esc
electrical connections with a
length of 3/32” shrink tube
installed over each connector.