Hull Construction Continued
☐
Seal area illustrated below with a minimum of
3 coats of lacquer spray. Remove mask.
☐
With the hull assembly inverted, register the
1/32 in. plywood bottom F13 with the F7
transom and R3 sides. Work from transom to
bow retaining ply bottom with masking tape
as illustrated.
Note: F13 should be placed
flush at transom and should overlap
basswood leading edge by at least 1/16 in.
☐
Support hull assembly against a flat work
surface rocking up onto the bow to flatten F13
ply bottom against the F16 basswood nose
stock then bond with CA glue.
☐
Support bow of boat against your flat work
surface and, working one “bay” at time, bond
all intersections of ribs, formers, and ply
bottom forward of F2 as illustrated.
Build Instructions
© 2013 Stevens AeroModel all rights reserved.
Page 10 of 25
F3
F4
F5
F6
R1
R1
F7
F13
R3
R3
F13
F3
F4
F5
F6
R1
R1
F2
Bottom View
Bottom View
Bottom View
Bottom View
Transom
Bow
Bow
