Catapult Assembly
Locate the hardwood dowel and the 24 in. x 1/8 in. rubber strip. These components are assembled to
create the catapult launcher. Please see the
Catapult Assembly
detail drawing on the plan set.
1.
Loop the elastic rubber strip in half, tie an overhand knot in the end within two inches,
where the loose ends meet. Pull the knot snug, working the knot within one-half inch of the
ends.
2.
Place the dowel on top of the rubber loop within two inches of the knot.
3.
Wrap the loop end of the elastic around the dowel and feed through the opening between
the dowel and the knotted end of the rubber strip and pull snug. Ensure that the knot is
located against the dowel.
Optional:
If desired, sand the model to remove the laser burn from the model. You may also paint the
model with clear-lacquer to protect it from moisture, or spray a little color on the model to make it uniquely
yours.
Please continue to the
Setup
and
First Flight
instructions to prepare the competed model for flight.
Build Instructions
scimon 30 V2 Build Instructions. © 2014 Stevens AeroModel all rights reserved.
!
Page 12
□
□
□
