Build Instructions
43. Matching tabs and notches, fit bottom
sheeting F14 within fuselage assembly
behind landing gear pocket and spanning
fuselage sides.
Bond F14 to retain.
Attention: be careful not to allow glue to
enter landing gear pocket.
44. Fit and bond F15 bottom sheeting spanning
fuselage sides forward of former F3.
45. Fit and bond F16 bottom sheeting spanning
fuselage sides aft of former F3 to rear of
fuselage.
46. Fit and bond F17 top sheeting spanning
fuselage sides aft of former F3
47. Fit and bond F18 to rear portion of fuselage
top.
48. Revisit all interior formers previously dry fit or
tack glued, with CA glue to thoroughly bond
parts.
49. Sand fuselage with sanding block and 400 grit
paper. Remove protrusion of F11 forward of
F7 windscreen. Lightly radius corners of
fuselage.
50. Cover fuselage using a high quality light
weight covering film. We suggest AeroLITE
by Stevens AeroModel. Note that the plan set
contains a trim guide for the scalloped
covering scheme represented on the product
packaging. Windows may be left open or
covered using clear AeroLITE or acetate.
Some modelers may choose to use an
opaque black or silver covering to represent
the windows instead of leaving them clear or
open.
KIT UPDATE 02.01.2011
We now provide a laser cut Acetate wind
screen. Remove backing paper from
windscreen and fold at edges of “front”
window. Use the plan set as a guide to
position the wind screen within fuselage and
retain using canopy glue or medium CA glue.
Set the fuselage aside until final assembly.
QuickOats™ (100)
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
Page 11