8
a)
On the radio/player, play any musical signal and set the volume to 80% of
the maximum (if the maximum volume of the radio /player is 45 (100%), set to 36
(80%).
b)
On the amplifier, begin with the LEVEL control at minimum, increase
gradually until the LED CLIP starts to flash. Slowly decrease the LEVEL until the led
goes out completely.
WEAK OF BASS:
▪ Cables of the speakers may be reversed and (speakers out-of-phase).
NOISE AND FAILURE IN SOUND:
▪ Make sure that the installation is not close to the vehicle’s
original
wiring
as it may cause interference and noise in the audio signal.
▪ Create a separate power connection for the sound system. Use a fuse/
circuit breaker as close to the battery as possible for protection.
▪ Make a good grounding for the amplifier. To do this, remove the paint
from the vehicle chassis at the desired point. Attach the wire using a ground
terminal. To prevent oxidation, isolate with paint.
▪ Do not loop the ground. Avoid using multiple grounds. If possible, use a
star connection, so all the grounds run from a single point.
Images contained in this manual are merely illustrative and may differ from the actual product.
Any updates made in this manual will be available for customers to consult free of
charge on the brand’s site.
It is recommended that the updated manual be consulted whenever needed.
The data measured are based on STETSOM laboratory equipment. Test reference in frequency
from 60hz to 1Khz with THD + N at ≤1% in impedances as indicated in each measurement. The
electronic components and the manufacturing process may present manufacturing variations,
thus leading to a variation in the measurements made.
