STERWINS 3276000313922, Сборка, использование, руководство по обслуживанию

Страница: 56 / 65

EN
55
SAFETY INSTRUCTIONS
all times. Do not overreach. Never
stand at a higher level than the
base of the machine when feeding
material into it.
5. Always stand clear of the discharge
zone when operating this machine.
6. When feeding material into the
machine be extremely careful that
pieces of metal, rocks, bottles, cans
or other foreign objects are not
included.
7. If the cutting mechanism strikes any
foreign objects or if the machine
should start making any unusual
noise or vibration, immediately
shut off the power source and allow
the machine to stop. Disconnect
the machine from the supply and
take the following steps before
restarting and operating the
machine:
i) inspect for damage;
ii) replace or repair any damaged
parts;
iii) check for and tighten any loose
parts.
8. Do not allow processed material to
build up in the discharge zone; this
may prevent proper discharge and
can result in kickback of material
through the intake opening.
9. If the machine becomes clogged,
shut-off the power source and
disconnect the machine from
supply before cleaning debris.
10.Never operate the machine with
defective guards or shields, or
without safety devices, for example
debris collector in place.
11.Keep the power source clean of
debris and other accumulations
to prevent damage to the power
source or possible fire.
12.Do not transport this machine while
the power source is running.
13.Stop the machine, and remove plug
from the socket.
Disconnect the supply and make
sure that all moving parts have
come to a complete stop
- whenever you leave the machine,
- before clearing blockages or
unclogging chute,
- before checking, cleaning or
working on the machine.
14.Do not tilt the machine while the
power source is running.
Follow below recommendations
when using the product:
1. Operate the machine only at
reasonable hours – not early in
the morning or late at night when
people might be disturbed.
2. Use rakes and brooms to loosen
debris before blowing/vacuuming.
3. Slightly dampen surfaces in
dust conditions or use mister
attachment.
4. Use the full blower nozzle extension
5. Supply the product via a residual