6
7
Important Note
Before wall construction and tiling, make sure all parts are
connected properly and securely.
B1
B2
3. Faucet and Soap Dispenser
Position Setup
Adjust the horizontal position of the
faucet base and the soap dispenser
base.
Note:
Do not remove the dust covers.
4. Plumbing
Fasten the waste pipe (B1) to the iron
frame using the bracket (B2).
Cut the lower part of the waste pipe
to the desired length, and connect it
to the main waste line.
Perform this part of the installation
after the wall and floor construction is
completed.
At this point the following parts will
protrude out of the wall:
• Faucet and Soap Dispenser bases
with dust covers (C1).
NOTE: It is recommended to fill the
cavities around the base with cement
to better secure it inside the wall.
• Two threaded rods covered with
protective plastic sleeves (C2)
• Faucet and soap dispenser corrugated
tubes (C3).
• Water inlet pipe opening (C4)
• Waste outlet pipe (C5).
5. Sink Installation
Cut the threaded rod to the length
that will fit the selected sink.
Cut the rod cover sleeves, just
enough to expose the threading at
the end of the rods ends.
Install the sink onto the threaded
rods, and fasten it to its place using
the sink fastening set (D1).
Connect the sink trap to the waste
outlet pipe in the wall (D2).
INSTALLATION
INSTALLATION
D1
D2
150 mm
C1
C2
C3
C4
C5
