BJ5-620 Maintenance 42
of
73
8.
Pivot the screen support into the working position and fasten using
mounting screws.
9.
Close the machine door.
10.
Shredder can be started again.
(Please refer to image from “Emptying the Screen”.)
V-Belts
V-belts are wearing parts that stretch and must be re-tensioned. Regular checks on the
tension force of the V-belts and the condition of the V-belts are necessary in order to
guarantee a long service life of the V-belts.
Checking the tension force of the V-belt
1.
Remove the V-belt cover.
2.
Measure the distance between the roller centres.
3.
Determine the belt sag force F for each belt at 16 mm sag if sag "b" is
equal to 1 m distance between roller centres. Do this by measuring the
distance between roller centres at a right angle to the V-belt.
Force required for 1m distance between roller
centres and 16mm sag
4.
Compare determined value with the value in the above table. If the value
lies below the lowest tolerance limit, the V-belt must be re-tensioned. If
the value lies above the highest tolerance limit, the V-belt must be relaxed.
Profile section
Efficiency of x in
mm
P in Newton
P in lbs
SPA
100 - 132
20 - 27
4,4 - 5,9
SPA
140 - 200
27 - 35
5,9 - 7,7
SPB
160 - 224
35 - 50
7,7 - 11
SPB
236 - 315
50 -65
11 - 14,3
SPC
224 - 355
60 - 90
13,2 - 19,8
SPC
375 - 560
90 - 120
19,8 - 26,4
XPB
224 - 250
25 - 35
5,5 - 7,7
Содержание SXS 1500
