19
PARAMETER
SETUP
Parameter setup is used to configure the operating mode of the XC780. All
counting, setpoint, and communications parameters are configured by selecting
the appropriate entry.
All parameters are stored in non-volatile memory. This means that even if
power is disconnected, all entered parameters will be saved.
During parameter setup, some keys have alternate functions:
PRINT:
The PRINT key is used to select the currently entered parameter
value and advance to the next parameter.
TARE:
The TARE key is used to select the currently entered parameter
value and back up to the last parameter.
SCALE SELECT:
The SCALE SELECT key is used to select from the options
available for each parameter.
COUNT:
The COUNT key is used to jump directly to the parameter you wish to
modify. By pushing the COUNT key at any time in parameter setup, the "SEtUP"
message appears. The number following the message indicates the number of the
current parameter. By entering the number of the desired parameter and
pressing the PRINT key, the operator can jump directly to that parameter.
SHIFT/CLEAR:
The SHIFT/CLEAR key is used to return the value of the parameter to
its default setting.
RESET:
The RESET key is used to exit parameter setup.
The J3 jumper on the XC780 logic board is used to lock out entry into the
parameter and calibration setup modes. Placing a jumper plug on J3 will lock
out entry into the setup modes, removing the jumper enables access.
J3
location
drawing
Some of the messages on the main XC780 display during parameter setup are
cryptic. Use the examples shown in the manual to guide you through.
Entering Parameter Setup:
Step 1:
Enter the numbers [8], [6], [2], [4] on the numeric keypad and
Содержание XC780
Страница 1: ...STERLING SCALE XC780 HIGH ACCURACY PIECE COUNTER OPERATION MANUAL ...
Страница 2: ...rev V1 1 07 02 91 ...
Страница 4: ...Sterling Scale reserves the right to make any refinements or changes without notice ...
Страница 6: ...2 Counting ...