Cleaning SterileLightTM CountDownTM PLUS Medical Grade Anti-Microbial
Screen Protectors
Item# SL-CD-PLUS
You can clean the top surface with any cleaner. If you notice that dust particles have gotten on the adhesive,
they can be removed.
Step 1:
Gently lift the corner of the CountDown PLUS anti-microbial
film near the dust particle using a piece of adhesive tape or a
fingernail being careful not to damage the backside of the film.
Step 2:
Using a small piece of adhesive tape, gently touch the film
with the tape to pick the dust particle off the tacky surface.
Step 3:
To clean the entire back surface, remove the entire film
and place it back side up.
Step 4:
Using adhesive tape, lay the strips on top of the tacky
surface, overlapping them as you add each one in succession until
you have covered the entire side of the film with adhesive tape.
Rub the adhesive tape against the film with a finger to ensure it will
adhere to the dust particles.
Step 5:
Once the entire surface is covered with tape, remove the
tape quickly and it will remove all the dust particles with it.
Step 6:
Return to Step 3 above if the screen needs to be cleaned
again and reinstall the film as indicated on the previous page.
Lay adhesive tape over the particle and then pull
back on tape to remove the particle
Sterile Light LLC
Email:
Toll Free: 833-525-5550
sterilelight.com
SterileLight makes no Warranty, expressed or implied, on the suitability or performance of this product, except to replace
product found to be defective. SterileLight assumes no liability for any damages that may result to other equipment due to
the use, misuse of, or inability to use the product.
