5
Operation
• Place the rework station on a flat
surface, and place the handle on its
shelf.
• Connect the power cord, fix the nozzle which you need (use the air flux knob
to
set the air capacity to max).
•
Switch the power on, set the temperature which you need using the buttons
(
▼
/
▲)
.
•
The unit will heat till it reaches the selected temperature.
•
After operation you must put the handle on its shelf. The unit will stop heating
automatically, and will enter standby state.
•
Disconnect the power if you don’t use the unit for a long time.
Note:
You can make the life span of the heating elements longer and make the IC chip safer
if
you do your work at a lower temperature and larger airflow.
Note:
When not using the gun, place it in your base, this will be activated automatically in
idle mode and avoid overheating when used again remove the gun from its base and
wait for dial again in the temperature display you chose
.
