Stepmaniax Machine Setup
ASSEMBLING the MAIN UNIT
The main unit of the machine is detached for shipping purposes and also needs to be installed.
1. THIS STEP REQUIRES TWO PEOPLE
Using 2 people, lift the
main monitor
unit
and insert the tubes into the
corresponding tubes on top of the main
unit, being sure not to pinch any cables
2. Secure the monitor by installing 4 of the
included screws into both the left and
right pipes underneath the monitor.
3. Remove the back cover from the monitor
by removing the 6 screws holding
the panel on (3 on top, 3 on bottom).
Connect all cables in the back from the
main unit into the top section monitor
unit. These include
HDMI, USB, power,
speaker audio (2), speaker power (2),
top marquee power, and WiFi Antenna.
Reinstall the back cover by replacing the
6 screws, and place the WiFi antenna on
the top of the machine.
4. Using 2 screws, attach the two speakers
to the sides of the monitor and connect
both the
power and audio cables
to
each. To connect the audio cables,
loosen each terminal, insert the
appropriate speaker wire, and tighten.
5. Remove the upper cover on each stage
by removing the 6 M4 screws. Unplug
the existing
DC Power Plug
inside of
the upper section of
each
stage and
completely remove the
internal power
supply
. Also unplug the
Micro USB
cable connected to the existing
Master
Control Unit
in
each
stage.
