Tech Support:
consumer.steppir.com/support | 425.453.1910 | [email protected]
2
Please review the following safety precautions carefully before putting the system into operation, so as to
avoid any personal injury or damage to the instrument and any product connected to it. To prevent potential
hazards, please use the instrument only as specified in this manual.
Use the Proper Power Cord
Use only the power cord designed for the instrument and authorized by your local country.
Ground the Instrument
The instrument is grounded through the Protective Earth lead of the power cord. To avoid electric shock, it is
essential to connect the earth terminal of the power cord to the Protective Earth terminal before connecting
any inputs or outputs.
Connect the Antenna Correctly
When connecting the Antenna to the Analytics Tower, ensure that all connections are fastened securely.
Utilize both screws on the DB
-
25 connecter to prevent accidental disconnection of the cable during use.
Observe All Terminal Ratings
To avoid fire or shock hazard, observe all ratings and markers on the system and check your manual for more
information about ratings before connecting the instrument.
Do Not Operate Without Covers
Do not operate the system with covers or panels removed.
Do Not Insert Anything into Vent Holes
Do not insert anything into the vent holes on the system to avoid damaging components.
Avoid Circuit or Wire Exposure
Do not touch exposed junctions and components when the unit is powered.
Keep Well Ventilated
Inadequate ventilation may cause an increase of temperature or damage to the system. Please keep the sys-
tem well ventilated and inspect the intake and vent holes regularly
Do Not Operate with Suspected Failures
If you suspect damage to the system has occurred, have it inspected by qualified service personnel before
further operation. Any maintenance, adjustment, or replacement, especially to circuits or accessories, must
be performed by SteppIR authorized personnel.
Keep Product Surfaces Clean and Dry
To avoid the influence of dust and/or moisture in the air, please keep the surface of the device clean and dry.
Electrostatic Prevention
Operate the instrument in an electrostatic discharge protective environment to avoid damage induced by
static discharges. Always ground both the internal and external conductors of cables to release static before
making connections.
GENERAL SAFETY SUMMARY
