2112 116TH AVE NE SUITE 1-5, BELLEVUE WA, 98004
WWW.STEPPIR.COM
TEL: (425)-453-1910 FAX: (425)-462-4415
!"#$"
%$
&'(
)*+
,
&'(
(*
#&
'(
NOTES:
Be sure to tighten all coax connectors so they are snug. Weather-proof with a coax sealant.
Tape all cables to the appropriate boom or mast to prevent sagging, which could create tension on the cables.
DO NOT kink or curve the cable to a radius of less than 3 inches. Allow for natural bends and secure cables to the
boom of mast of the antenna.
Do not secure the cable to anything that has a sharp edge including aluminum saddles, bolts, mounting plates etc.
Connect the 4 ft coax jumper 21-6301-70 from the driven element EHU to the SO239 labeled “OUT” located on the
rear of the 80m diple switch as shown in figure XX.
Connect the primary feed line (coming from the shack) to the SO239 labeled “IN” located on the rear of the 80m
dipole switch.
Connect the 4 conductor from the antenna switch terminal block to the connector junction box as shown in figure
XX. The wiring sequence is shown in figure XX.