Digital Microstep Driver DM556N
2
1 Product Instructions
1.1 Instructions
The DM556N is a fully digital stepper driver developed with advanced DSP control algorithm based
on the latest motion control technology. It is especially effective in devices where users expect low
cost, low noise. Its motor auto-identification and parameter auto-configuration feature offers quick
setup to optimal modes with different motors.
1.2 Features
The driver of DM556N features as bellow:
Wide control signal voltage range, from +5V to 24V. Can be used directly without any
external circuit
Low noise, low motor speed
Average current control, two-phase sinusoidal current output
The servo microstep DSP algorithm, low noise, low vibration
The max. power supply voltage can be 40VAC/50VDC
Output peak current from 1.4A to 5.6A
The standstill current can be set to half
Can drive 4, 6 and 8 wire two-phase, four-phase stepper motors
High-speed optocoupler isolation signal input, pulse response frequency up to 200 kHz
Strong anti-high frequency interference ability
Easy to set output current
Microstep accuracy: 2, 4, 8, 16, 32, 64, 128, 5, 10, 20, 25, 40, 50, 100, 125
Overvoltage, undervoltage, overcurrent, and phase-to-phase short circuit protection
The max motor speed:500RPM(Recommend value: 200RPM).If you need higher motor
speed,recommend DM556T.
1.3 Safety Instructions
The product is powered by AC/DC power supply, please confirm that the power supply
voltage is within the allowable range.
Do not plug or unplug the cable when power on.
This product is not sealed, do not mix conductive foreign matter or flammable materials
inside. Pay attention to moisture-proof.
Keep the operating environment cool and ventilated when in use.
Connect to the stepper motor, adjust the current, work continuously for half an hour and
observe if the temperature is in the rated range. If the motor temperature is too high, please
contact the us.
