Stels 51133, Руководство пользователя

Страница: 12 / 32

12
ENG
It is prohibited to stay or carry out works under the lifted load held only by the jack. Stay away from moving
hinged joints of the jack.
Never exceed the maximum rated lifting capacity of the jack. Overload of the jack may result in its failure
and cause personal injury.
The safety valve is adjusted for safe operation of the item with maximum rated load of 3 tons. It is prohibited
to change factory settings of the safety valve on your own; it may cause failure of the item and personal injury.
It is permitted to use only the components and adapters recommended for use by the manufacturer.
It is prohibited to disassemble the jack on your own initiative, as well as make changes into the construction
of the jack.
All warning labels should always be legible and these operating instructions should be kept intact during
the whole service life of the jack.
Failure to heed these rules may result in causing personal injury and failure of hydraulic equipment.
BEFORE USE
Assemble the handle of the jack pump. Insert the upper part of the handle into the lower part, align the holes
in them and insert the fixing screw by tightening it with the nut.
Install the handle assembly into the base and make sure that it is reliably fixed in the slot; and then tighten
it with the bolt. Try to rotate the handle in both directions – it should move freely.
Test the jack. For this, turn the handle clockwise until the release valve is firmly closed. Pump handle several
times up and down; when this is done, the lifting arm of the jack should start rising. To lower the lifting arm, turn
the release valve with the help of the handle counterclockwise by no more than three turns. When the lifting
arm is lowered completely, close the release valve by turning its handle clockwise as far as it goes.
ATTENTION!
Operation of the jack in the wrong position, on the side, in the upside down position
is not allowed.
JACK OPERATING PROCEDURE (THROUGH THE EXAMPLE OF VEHICLE LIFTING)
Make sure that the vehicle and jack are on smooth and hard surface and the jack has a possibility to be
displaced during lifting and lowering of the vehicle. Uneven, soft or slanted surfaces create hazard for the
execution of works.
Apply the parking brake in the vehicle, turn the automatic gearbox selector into the Р position or engage
the first gear in the vehicles with the mechanical gearbox; place vehicle wheels for straight-driving direction.
2 3 1
HYDRAULIC FLOOR JACK