INSS0711
Programmable heating cycle
This setting allows the length of a heating cycle to be adjusted.
To activate this programmable heating cycle setting, the
thermostat should be in Day mode and the user must press
and hold down the (+) and (-) buttons for 20 seconds. Note
that the SET icon will blink after 3 seconds, but you must
hold down the buttons until SEC appears at the bottom of the
screen. Then, release the buttons. It is important to keep the
two buttons pressed down to avoid switching to the Security,
Fan or Celcius/Fahrenheit modes. After the 20 seconds, the
three top figures will display the number of seconds for a
heating cycle and SEC will be displayed at the bottom of the
screen.
Heating power indicator
The level of power used to maintain the temperature at the
set point is expressed as a percentage indicated by the
number of bars in the thermometer displayed. The heating
power used is displayed as follows:
4 bars = 75% to 100%
3 bars = 50% to 75%
2 bars = 25% to 50%
1 bar = 1% to 25%
0 bar = no heat
Frost-free warning
The Snowflake icon is displayed when the temperature set
point is between 3°C (37°F) and 5°C (41°F). A minimum
temperature will be maintained to ensure frost control.
