3
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
Improper installation, use, operation or maintenance of this product may result in injury or death
from electric shock or fire. It may also result in property damage from ice dams. Read and
follow the instructions in this manual. If you have questions, contact °STELPRO for assistance.
Give this manual to anyone who will be using this cable, including future users/homeowners.
To reduce the risk of ice dam formation or injury or death from electric shock or fire,
follow all electrical requirements for using this product.
See the
Electrical requirements on
page 6
for details.
The SCRG-CONTROL accessory (controller for SCRG series cables with moisture and ambient
temperature sensors) is recommended for controlling these roof and gutter de-icing cables.
°STELPRO recommends you not use an extension cord with this cable.
If you are unsure whether your electrical receptacle meets these requirements, contact your
local electrical inspector or a licensed electrician.
1.
Avoid overheating the cable.
For example: Do not allow the heated portion of an operating
cable to touch, cross over or overlap itself or another de-icing cable. Do not operate the
cable in warm weather (above 10°C [50°F]). Do not install the cable where it might be
warmed by sources of heat, such as an exhaust vent or chimney.
2.
Do not alter or modify the cable in any way.
For example: Do not cut or splice the cable,
or paint or expose it to chemicals, such as glue, caulk or adhesive.
3.
Keep all combustible materials away from the cable
, such as leaves, pine needles,
seeds or windblown trash. Do not attach the cable to a combustible material, such as any
wooden parts of the eave.
4.
If using gutter guards, ensure that there is at least ½ in. (12.7 mm) clearance between
the gutter guard and cables.
5.
Do not use a cable that is damaged or has deteriorated.
Dispose of it. Signs of damage
include cuts, brittleness, charring, cracking, discoloured surface or bare wires.
6.
Use this product only as intended and described in this manual.
7.
To prevent creases, make sure the minimum bending radius is 1 in. (25.4 mm).
