stellar labs TMAX1, Руководство пользователя

Страница: 7 / 28

Tailgate Operation
Lowering the tailgate
Step 1: Pull upward on the red post/bar attached to the right side linkage of the tailgate.
Step 2: Now pull downward on the tailgate.
Closing/Stowing the tailgate
Step 1: Pull upward on the red post/bar attached to the right side linkage.
Step 2:
Push the tailgate upward until it stops.
Step 3: Pull downward on the red post/bar to lock the tailgate in place.
Operation 1
This chapter contains information regarding the operation of Stellar manufactured service
bodies. Please study the following pages to ensure your familiarity with the operation
process. This understanding is vital to the safe and efficient operation of the service body.
Stabilizer Operation
Before operating the stabilizers, make sure that the service truck is parked on an even sur-
face and be aware of the surface the truck has been positioned upon. The area should
be a firm supporting surface.
Note: Stand clear when deploying stabilizers.
Step 1: Fully extend the stabilizer beam. Note: Manual beams will have to be pulled out.
If equipped with a power out option, push downward on the far left valve bank
lever until the beam stops moving outward.
Step 2: Lower the curbside stabilizer leg by pushing down on the center valve bank lever.
Lower the stabilizer until it makes good contact with the firm supporting surface. If
equipped with manual crankdown legs, manually lower the legs until they make
good contact with the supporting surface. Avoid over-extending the stabilizers
legs. The truck tires should remain in contact with the ground surface.
Step 3: Lower the streetside stabilizer leg by pushing downward on the right valve bank
control lever. Lower the stabilizer until it makes good contact with the firm support-
ing surface. If equipped with manual crankdown legs, manually lower the legs
until they make good contact with the supporting surface. Avoid over-extending
the stabilizers legs. The truck tires should remain in contact with the ground sur-
face.
Air Drain Operation
Depending on where and how the air drain valve is mounted to the body determines the
operation. Follow the decal instructions for correct positioning of the valve handle.
Note: Always drain air tank/receiver before leaving a job or work site. Air tank should not
have compressed air while driving the service truck.
Masterlock Operation
Step 1: Close all doors.
Step 2: Push and hold locking bar in the detent position.
Step 3: While holding locking bar in detent position, insert locking device in aligned holes.
Note: Perform these steps for each applicable side pack.
Chapter 1 - Operation