stellar labs TireMan 12154, Руководство пользователя

Страница: 9 / 40

Stellar
®
TMP12154 Owner’s Manual | Page 5
Installer Notice
According to Federal Law (49 cfr part 571), each final-stage manufacturer shall complete
the vehicle in such a manner that it conforms to the standards in effect on the date of
manufacture of the incomplete vehicle, the date of final completion, or a date between
those two dates. This requirement shall, however, be superseded by any conflicting
provisions of a standard that applies by its terms to vehicles manufactured in two or more
stages.
Therefore, the installer of Stellar
®
Tire Manipulators and Bodies is considered one of the
manufacturers of the vehicle. As such a manufacturer, the installer is responsible for
compliance with all applicable federal and state regulations. They are required to certify
that the vehicle is in compliance with the Federal Motor Vehicle Safety Standards and
other regulations issued under the National Traffic and Motor Vehicle Safety Act.
Please reference the Code of Federal Regulations, title 49 - Transportation, Volume 5 (400-
999), for further information, or visit http://www.gpoaccess.gov/nara/index.html for the full
text of Code of Federal Regulations.
Chapter 2 - Installation
General Installation
This chapter is designed to serve as a general guide for the installation of a Stellar TM12154
on a Stellar Service Body. Each installation is considered unique so certain portions of this
chapter may or may not apply to your direct application. If a question should arise during
the installation process, please contact Stellar Customer Service at (800) 321 3741.
This tire manipulator (TM) is designed for use with a Stellar Service Body installed on
a vehicle that meets the minimum chassis requirements of the TM. It is the installer’s
responsibility to assure that the TM is mounted on a platform that will support the maximum
rating of this TM.
Do not install this TM on a body not capable of handling the loads
imposed on it. Failure to do so may result in serious injury or death.
When installing welder units to the service bodies, it is highly
recommended that a surge protector is installed on the chassis batteries to protect the TM
radio receiver, wiring and other electronic devices from an unexpected electrical spike
or surge. Failure to do so could result in extensive damage to the service body and TM
electrical circuit.
WARNING
NOTICE