Manual, 84-12-9 G
2
Hydraulic Hook Lift Specifications
Lifting Capacity:
9,000 pounds gross weight evenly distributed in, or on, body.
Container Length:
10-foot through 13-foot from front A-frame to rear of skid rails. Longer bodies may
be accommodated if full dump angle is not required (may require special body-
mounted or extendable truck-mounted bumper to meet the Office of Motor Carrier
Safety (OMCS) Rear End Protection regulation 393.86)
Maximum Dump Angle:
43
°
with a 10-foot body and 38° with a 13-foot body
Operating Pressure:
4200 PSI maximum
Weight of Loader:
Loader weight not to exceed 1,500 pounds
Height of Loader:
Loader height not to exceed 5 1/2” as measured from top of truck frame to top of
loader rollers
Hook Height:
35.63-inches from bottom of skid rails to bottom of hook bar. Loader must be able
to pick up 10-inches below grade when mounted on a truck with 36” frame height.
Hydraulic Pump:
Direct-coupled high-pressure gear pump.
Hydraulic Control Valve:
Stack
-type valve mounted directed onto the oil reservoir.
Controls:
Dual manual levers with sealed cable actuators mounted in the truck cab to allow
full feathering of all loader functions.
Tilting Hook Assembly:
Loader must have pivoting type front tilt section (jib) to provide a low degree
loading/unloading angle. Hook to include automatic mechanical safety latch, which
disengages only when the container/body is in proper position to be picked up or
dropped off.
Tilt Cylinder:
Single 3-inch bore with 1-1/2-inch diameter rod cylinder. Cylinder must be double
acting and include dual integral pilot-operated counterbalance valves to prevent
cylinder collapse in case of hose failure.
Lift/Dump Cylinder:
Single 4-inch bore with 2-inch diameter rod cylinder. Cylinder must be double
acting and include dual integral pilot-operated counterbalance valves to prevent
cylinder collapse in case of hose failure.
Rear Body Hold-Downs:
Dual fixed-position hold-down devices mounted to the dump frame to secure the
body to the loader through all ranges of the dump mode. This must be accomplished
without the use of steel springs and/or hydraulic/air cylinders.
Pins & Bushings
All pins to be hardened chrome steel. All bushings to be of the permanently
lubricated variety. No grease zerks allowed.
Hoses & Hydraulic
All hoses and fittings are to be SAE: metrics not allowed. O-ring face seal
Fittings:
fittings to be utilized wherever possible.
Origin of Manufacture:
Loader to be designed and manufactured in the United States of America.
