Stell SOS 3000, Инструкции по установке и Руководство пользователя, Страница: 6 / 64

Operating Control Panel
Timer
Memory /Screen
lock (unlock)
Downward
movement
Upward
movement
Memory
1 / 2 / 3
Display
Timer
indicator
Operation Instruction:
Activate the System: Touch the screen. The “---” will appears on the display. Then, press and hold the “M” button for 3 seconds. The current
height will display, and you can start operating the system.
Height Adjustment: Press and hold the up button to lift the desk. Press and hold the down button to lower the desk.
Timer: The timer is designed to inform users to stand up after a set period of time. Press the “T” button to set the period of time. The display
will fl ash “0.5 h” for 0.5 hour. Each press of the “T” button leads to a 0.5 hour increment. The maximal setting of time is 2 hours. When the
display stops fl ashing, then the period of time is successfully set. And the indicator light on the top right of panel will be on. When the set time
is up, the buzzer will beep to remind the users. The timer will turn off automatically after a long beep. To cancel the timing, press “T” button for
5 times until the display shows the current height and the indicator light is off.
Memory Setting: Adjust the desk to your desired position. Press the “M” button, then “S-” appears on the display. Press “1”, “2” or “3”. The
memory is successfully set. You can store up to 3 heights by repeating the same process.
Protective Standby Mode: If there is no operation for 1 minute, the system will enter the protective standby mode. To turn off the standby
mode, press and hold the “M” button for 3 seconds. You can also press and hold the “M” button for 3 seconds to activate the standby mode,
when you don’t need to operate the system.
Power-saving Mode: When no actions are made for over 10 minutes, the system will enter power-saving mode. Press any buttons to enter
operation mode.
Measurement Switch (cm/inch): Restart the system. Press “T” for 8s. The buzzer will beep twice. The measurement is changed from
centimeter to inch. If you want to switch the measurement back to centimeter, also press the “T” for 8s.
Reset Mode: While the system is reconnected, press the down button until “RST” is displayed. Continue to press the button. The desk
will move down and then raise a little bit. (Make sure you never release the button during the process.) After the movement stops, the system
is successfully reset to the starting position.