12 – EN
IMPORTANT SAFETY INFORMATION
•
Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not
use damaged or faulty parts.
•
Read all instructions before installing the equipment. When you are unsure about any part of the
installation process, ask a professional technician for help.
•
When tightening the screws, be careful to avoid stripping the thread.
•
Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is
designed to be mounted on a wall of bricks and concrete. For installation on walls made of other materials
consult a professional.
•
Never install or use this product if there are signs of damage.
•
The edges of the equipment may cause injury if they are handled improperly.
•
This device is not designed for assembly or handling by small children, or persons, who have not been
specifi cally instructed unless supervised by a responsible person to ensure safety during handling or
installation. Children should be supervised to ensure that they do not interfere with the equipment.
Do not allow children to hang on the equipment or otherwise handle it. Otherwise, there is a danger of
serious injury. Never insert your fi ngers or other objects into the mechanism of the equipment. It could
cause personal injuries or property damage.
•
The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these
parts out of reach of children!
Note:
Specifi cations and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
A
Body of the mount
B
Left bracket
C
Right bracket
D
Screw M6×30
E
Screw M8×30
F
Washer M6/M8
G
Washer under the screw
H
Spacer M6/M8
I
Screw M8×90
J
Expansion plug M10×80
INSTALLATION
This TVG mount must be securely fastened to a vertical wall. If not solidly installed, it
could fall and cause injury or damage.
Installing the mount on the wall of solid brick or concrete wall or panel
Mark the position of 4 holes on the wall (one in each corner of the holder body) for attaching the body of
the holder. Use the body of the holder
A
as a template (
Fig. 1
). Use a spirit level to make sure the holes are
horizontal. Use masonry drill (10 mm) to pre-drill holes at least 9 cm deep and insert plastic anchor into each
J
. Check that the plastic anchor is entirely inserted and even with the wall. (
Fig. 2
). Attach the body of the
holder to the wall using four screws
I
and washers
G
, as shown in
Fig. 3
.
Levelling the mount
After installing the wall mount, you can later adjust the horizontal position of the plate to mount the TV.
Loosen the screws on the TV mounting plate using Phillips screwdriver and use the spirit level to align the
plate horizontally (
Fig. 4
). Tighten the screws after you level the plate (do not use excessive force).
Note:
If the TV is not entirely horizontal after installation on the mount, remove it from the mount (perform the
points from the pictures
6
and
7
in reverse order), repeat the process of levelling and then reinstall the TV set.
EN – GENERAL INSTRUCTIONS FOR INSTALLATION
