30
Can´t Turn On Via LAN or Control System
•
The Model P200 needs to be set to Network mode to be able to turn on via a control
system. It will not turn on when in Deep Sleep. In the web interface, this is set up in Device
Management -> Power. In the OSD interface, this is set up in System Configuration –Z
General Setup.
•
The Model P200 cannot turn on from standby via LAN B; please use LAN A instead.
Retrieving and Sending an Error Log
To retrieve an error log, you need to access the Model P200 via your browser. Here you can
download a text file and email it to your Steinway Lyngdorf representative.
3D Compatibility Not Detected
If the Model P200 isn´t fully booted, a Blu-ray player will not be able to detect its 3D compatibility.
Remote Control Doesn´t Work
The remote control is paired to the Model P200 at the factory; you only need to pair it again if you
have a new Model P200 or remote. To pair the RF remote control to a Model P200:
1. Turn on the Model P200.
2. Hold down Play & OK until the remote control´s green LED flashes.
3. Point the remote control at the Model P200 and hold it within 30cm / 1 foot of the front panel;
when the green LED stops blinking, the remote is connected via Zigbee.
4. The remote will be paired to the Model P200.
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
To switch the remote back to RF mode, hold down OK and 2. The LED will flash green twice.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Which audio formats does the USB port support?
The USB port supports the following audio formats:
•
mp3, wma, wav, ogg, flac, m3u, pls, wpl, m4a, aac, asx, aif, aiff
