STEININGER ROCK.AIR, Руководство пользователя

Страница: 24 / 25

24
• It is easiest to clean the unit while it is still warm.
Stainless steel surfaces
Important information
• Salt residue must be removed immediately. Combined with stainless steel, it can form hydrochloric
acid, which will irreparably damage the stainless steel.
Cleaning and care
• A commercially available grease cleaning agent can be used for daily cleaning. After cleaning, rinse
with plenty of clear water, as cleaning agent deposits will be difficult to remove at a later point.
• The best approach for coarse dirt is to soften it with brake cleaner or silicone remover and then re-
move it using a soft (cotton) cloth.
• Never scrape marks or encrustations off the surface. It is best to soak stubborn encrustations for a
while, as this makes them easier to wipe off.
• As a general rule, after being cleaned with any kind of cleaning agents, stainless steel surfaces must
always be wiped thoroughly with clean water and dried.
• You can remove limescale marks on the stainless steel easily with a splash of vinegar in the cleaning
water or ten percent citric acid.
• Do not clean using steel wool, scouring pads, scouring agents or agents containing chlorine, iodine or
bromine.
Powder-coated surfaces:
• Use only pure water, if necessary with the addition of a small amount of neutral detergent (pH7) and
then soft, non-abrasive cloths or industrial cotton wool.
• Use lint-free cloths.
• Moderate mechanical assistance in the form of a soft brush that will not damage the surface is permit-
ted for cleaning.
• Refrain from rubbing hard.
• Remove greasy, oily, sooty substances, glue, silicone rubber or adhesive tape with aromatic-free white
spirit or isopropyl alcohol (IPA).
• Do not use any solvents containing esters, ketones, polyhydric alcohols, aromatics, glycol ethers, halo-
genated hydrocarbons or similar substances.
• Do not use any grating, abrasive agents or strongly acidic or alkaline cleaning and wetting agents.
• When cleaning, the temperature of the cleaning agent and surface should be a maximum of 25°C.
• The cleaning agent must not be left applied to the surface for more than 1 hour. The entire cleaning
process can be repeated after 24 hours if necessary.
• After every cleaning process, rinse with pure, clean water.
CLEANING AND CARE