steinert UME 115 130 C, Инструкция по эксплуатации

Страница: 41 / 86

Over-belt magnetic separator UME … C
Faults
41
GB_UME 75-135 ... C-03-US
If malfunctions occur more frequently:
Reduce the maintenance intervals according to the actual
requirements.
If malfunctions cannot be eliminated by following the hints below:
Contact the manufacturer.
9.1 Behaviour in case of malfunctions
Press the EMERGENCY STOP button immediately in case of
malfunctions which cause immediate danger to personnel or
material assets.
Determine the cause of the malfunction.
Switch off the plant and secure it against switching on if
malfunction elimination requires working in the danger area.
Inform the supervisor on site of the malfunction.
Depending on the malfunction, have authorized specialists
eliminate it or eliminate it yourself.
Personnel
Unless otherwise indicated, the work to remedy malfunctions which
is described here can be performed by the operator.
Some work may only be performed by specially trained personnel
or only by the manufacturer. This is indicated in the description of
the individual fault.
Work on the electrical system must only be performed by a
qualified electrician.
9.1.1 Troubleshooting work
If off-track running, single-sided wear or partial destruction of the
conveyor belt are identified, immediately check the setting of the
discharge belt, see "Adjusting/tensioning the discharge belt".
Upon identification of damage or partial destruction of the
discharge belt, immediately stop the machine and replace the
discharge belt.