Functional Warranty
Declaration of conformity
This product complies with
Low Voltage Directive
06/95/EC, EMC Directive
04/108/EC and RoHS
Directive 02/95/EC.
This Steinel product has been
manufactured with utmost
care, tested for proper opera-
tion and safety and then sub-
jected to random sample in-
spection. STEINEL undertakes
the guarantee for perfect con-
dition and function.
The warranty period is 36
months and starts on the date
of sale to the consumer. We
will remedy defects caused by
material flaws or manufactur-
ing faults. The warranty will be
met by repair or replacement
of defective parts at our own
discretion. The warranty shall
not cover damage to wear
parts, damage or defects
caused by improper treatment
or maintenance. Further con-
sequential damage to other
objects is excluded.
Claims under the warranty
shall only be accepted if the
product is sent fully assem-
bled and well packed com-
plete with a brief description of
the fault, a receipt or invoice
(date of purchase and dealer's
stamp) to the appropriate Ser-
vice Centre.
Repair Service:
Our Customer Service Depart-
ment will repair faults not cov-
ered by warranty or after the
warranty period. Please send
the product well packed to
your nearest Service Centre.
21
Troubleshooting
Malfunction
Cause
Remedy
20
Light does not switch ON
No supply voltage
Lux value set too low
No motion detection
Check supply voltage
Slowly increase lux value
until light switches ON
Establish a clear view of
the sensor
Check detection zone
Light does not switch OFF
Lux value too high
Overshoot time running out
Interferring sources of
heat, e.g.: fan heaters,
open doors and windows,
pets
Reduce lux value
Wait until overshoot time
elapses; reduce overshoot
time if necessary
Blank off stationary
sources of interference
using shrouds
Sensor switches OFF
in spite of occupancy
Overshoot time too short
Increase overshoot time
Sensor switches OFF
too late
Overshoot time too long
Reduce overshoot time
Sensor switches ON too
late when approached
frontally
Reach is reduced when
approached frontally
Install further sensors
Reduce distance between
two sensors
Sensor switches
too frequently with chang-
ing cloud cover
Overshoot time set too
short
Increase overshoot time
more pleasant switching
behaviour
only BLS D, DF:
Sensor does not react to
changes in brightness in
test mode
Control leads (+,–)
not correctly wired
Replace the control leads
on the sensor
or
electronic
ballast
only BLS DF:
Sensor does not switch ON
with occupancy in spite of
darkness
Sensor previously switched
OFF with hand-held trans-
mitter
Lux value selected too low
Activate sensor by press-
ing the (+) button on the
hand-held transmitter
Increase lux value on the
sensor or by pressing the
(+ ) button on the hand-
held transmitter
The light level set with the
hand-held transmitter is no
longer saved
Settings deleted, since
voltage supply to the sen-
sor cut off
(e.g. by light switch or
power failure)
Ensure voltage supply to
the sensor
LuxMaster_10spr 27.08.2008 13:32 Uhr Seite 22