STEINEL Control Pro DT Quattro DCS, Руководство пользователя

Страница: 44 / 63

- 44 -
Note on parallel connection:
Several sensors can be connected
on the same bus. Check technical
specifications of the DCS for
maximum number of bus participants.
5. Mounting
• Check all components for
damage.
• Do not use the product if it is
damaged.
• Select an appropriate mounting
location, taking the reach
and motion detection into
consideration.
(Fig. 3.3/3.4/3.5/3.6)
Mounting procedure 1
• Drill a hole in the ceiling of
min. Ø 2.67 in (68 mm)/max.
Ø 3.00 in (76 mm). (Fig. 5.1)
• Connect to the bus powered
data line of the room controller.
(Fig. 4.1/5.2)
• Mount directly to ceiling with quick
mount spring tabs.
(Fig. 5.2)
• Insert the sensor into the load
module. (Fig. 5.2)
• Wait for the system to reboot.
• Make settings.
➔
"6. Function / Setting"
• After installing the sensor starts
to flash once a second for aprox.
2 minutes. Follow the next steps
on the commissioning App of
the DCS.
Mounting procedure 2
• Connect to the bus powered
data line of the room controller.
(Fig. 4.1/5.3)
• Mount the power module to
a 4" Square box, 4" Octagon
box or Round 3.0 Mud-Ring.
(Fig. 5.2/5.3/5.4)
• Mount the sensor module to the
power module by carefuly opening
the locking tabs on the side of the
sensor module. (Fig. 5.3/5.4)
• Wait for the system to reboot.
• Make settings.
➔
"6. Function and Settings"
After installing,the sensor starts
to flash once a second for aprox.
2 minutes. Follow the next steps on
the commissioning App of the DCS
6. Function / Setting
The motion detection values and light
levels measured by the sensor can
be requested from the DCS controller
App.
LED function
Blue LED:
– During installation and Data Line
addressing, LED flashes 1 x per
second.
– After initialization is concluded the
LED will turn off indicating normal
working mode.
– In case of a Data Line bus reset,
the sensor LED will blik indicating
sensor adressing.