- 25 -
- 24 -
Light function
DIP switch 2
mode
Switch
configuration DIP
switch 4
Status
Switch function
Fully automatic
mode (AUTO)
-
Lighting is
switched OFF
Lighting is switched
ON for the stay-ON
time selected.
Fully automatic
mode
ON-OFF
Lighting is
switched ON
Lighting is switched
OFF for the stay-ON
time selected and
re-triggered on
detecting movement
(inverse mode /
presentation mode).
Fully automatic
mode
ON
Lighting is
switched ON
The stay-ON time se-
lected is re-triggered.
Semi-automatic
mode (MAN)
-
Lighting is
switched OFF
Lighting is switched
ON for the stay-ON
time selected.
Semi-automatic
mode
ON-OFF
Lighting is
switched ON
Lighting is switched
OFF until it is next
activated.
Semi-automatic
mode
ON
Lighting is
switched ON
The stay-ON time se-
lected is re-triggered.
8� Technical specifications
Dimensions W
x
H
×
D
80
×
80
×
50 mm
Supply voltage
220-240 ~V / 50/60 Hz
Sensor system
Passive infrared (IR)
Reach
max. 20 m
Angle of coverage
180°
Capacity, switching output 1
Relay 230 V
max. 200 W resistive load (cos φ = 1)
max. 6 fluorescent lamps /
LED lamps C < 132 µF
max. 100 VA (cos φ = 0.5)
Minimum connected load
3.5 W
Light-level setting
2-1000 lux, ∞ / daylight
Time setting
30 s - 15 min
Mounting height (minimum)
1.1 m
IP rating
IP20
Temperature range
0°C to + 40°C
9� Troubleshooting
Malfunction
Cause
Remedy
Light does not switch ON
n
No supply voltage
n
Lux setting too low
n
No motion being
detected
n
Check supply voltage
n
Slowly increase lux set-
ting until light switches
ON
n
Ensure unobstructed
sensor vision
n
Check detection zone
Sensor responds
when it should not
n
State of charge not
sufficient
n
With a very low state
of charge, lighting is
switched ON irrespec-
tive of movement, see
SuperCap charging
behaviour