Steinberg Systems SBS-KW-1TE, Руководство пользователя

Страница: 34 / 56

5. BattEry and charging
When there is low power in the battery, specifically when the voltage is less than 5.4V,
the scale will alarm by displaying LB. The scale need to be charged now.
When the battery is less than 5.25V, the scale will go into sleeping mode. It will repeat
displaying U5.2 and the buzzer will give out alarm sound instantly. Then the scale must
be charged.
The scale will power off automatically after displaying LB for 20 times without charging.
It can be charged no matter the scale is switched off or during working. It takes around
8 hours to fully charge the battery. In recharging the battery, the AC lamp on the front
panel will be red. When the light is green, it indicates the battery is charged fully. The
recharged battery voltage will be shown during restarting the scale.
6. PrEcautions
Electronic crane scale is precise measuring instrument, safety precautions should be
always followed including the following:
6.1
Do not exceed the maximum weight capacity
6.2
Lift and descend goods vertically and dragging goods is forbidden.
6.3
Please check whether the screws, bolt and circlip are loosened or
disengaged before use to ensure safety and accurate measurement
6.4
Avoid any intensive impact and long rain catching. When using outdoor,
please turn off the crane scale if there is a thunder.
6.5
When working under high temperature, please buy high-temperature crane
scale. The distance between the bottom of crane scale and the hanged
heating source should be more than 1600mm. The temperature for weighing
article should not be higher than 180°C and long time working under high
temperature is forbidden
6.6
Do not overload to avoid the damage of sensor. When the weight reaches
120%F.S, the system will give alarm sound. Please remove the overload
weight immediately.
En
34