Steinbach 049275, Оригинальное руководство пользователя, Страница: 57 / 285

The display
14
shows the desired parameter (A, C, 1-8) (see "Parameters").
3. Press the SET button
18
to select the desired parameter.
The value of the selected parameter blinks on the display
14
.
Set parameter
1. Repeatedly press the Up button
16
or the Down button
17
.
The desired value of the selected parameter blinks on the display
14
.
2. Press the SET button
18
.
The desired value of the selected parameter is set.
Deinstallation
CAUTION!
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the
device can result in injuries or damage to the device.
- Only lift, carry or tip the device with two people, never alone.
- Pay attention to maintaining proper posture (straight back,
secure footing, etc.).
- Use transport aids (e.g. pallet truck, or creeper dolly).
- Wear protective equipment such as safety footwear or gloves.
Disconnecting the supply lines
Disconnecting the electrical
1. Put the heat pump into the Standby mode (see the chapter on “Display”).
2. Press the RESET button
12
.
3. Disconnect the RCD adapter
C
from the electrical supply.
The heat pump is now disconnected from the electrical supply.
Disconnecting the water lines
1. Switch off the water treatment pump.
2. Loosen the hose clamps
3
of the adapters
2
.
3. Pull the end of the hose off the adapter
2
on the inlet water connection
7
.
When removing the end of the water hose, hold it with the opening facing upwards
to prevent uncontrolled spilling of the remaining water present in the hose.
57
en