Steinbach 040310, Оригинальное руководство пользователя

Страница: 38 / 305

Connecting the lines
Prepare the following components:
- Pressure line
14
- Return, backflush and suction line (not included in the package contents)
- Assembly materials for the lines
To connect the lines to the pump and filter vessel (see Figure A), proceed as follows:
1. Route the return and suction line from the pool to the filter system.
2. Route the backflush line from the duct connection to the filter system.
Observe the markings right at the line connections of the valve head.
The lines are connected.
Preparing the filter system
1. Press and hold down the valve lever
31
on the valve head
1
.
2. Set the valve lever to the "RÜCKSPÜLEN" (BACKFLUSH) position and release it.
3. Allow the filter vessel
2
to fill with water until the water runs out of the "WASTE"
30
backflush line.
4. Check the filter system and the connections for leaks.
5. Backflush the system (see section "Backflushing").
Operation
WARNING!
Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
-
Never operate water treatment system devices while persons are in the pool.
-
Prevent any access to the pool for as long as water treatment system devices are in use.
CAUTION!
Risk of injury!
A damaged device or damaged accessories may cause injuries.
-
Check the device and the accessories (see section "Testing").
NOTICE!
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
-
Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.
Selecting the mode
Switch the pump
3
off by pulling the power plug.
Press and hold down the valve lever
31
on the valve head
1
. Turn the valve lever to the desired
position and let go.
Pump operation
1. Make sure that all hoses and pipes are correctly connected and that the water level in the pool is at
least 1 to 2" (2.5 to 5 cm) above the opening of the suction line.
2. Check the valve setting of your filter system before you activate the pump.
3. Connect the pump's power plug to the power supply.
The pump is running.
38