page 9
5.
Deleting measured values
You can delete all measured and recorded values. The input data such as times, power prices,
CO2 factor and overload values remain intact.
1.
Simultaneously push and hold the buttons
DISPLAY
and
VALUE / +
for three seconds until
the entire display blinks.
2.
Simultaneously push and hold the buttons
DISPLAY
and
SET / OK
for three seconds.
3.
All measurement results are permanently deleted!
If you do not perform any action after step 1, the monitor returns to the standard display
mode after 10 seconds of inactivity.
Always delete the measurement results with full batteries of if the device is connected to
the grid.
6.
Initialisation
If the display has an unusual readout or the buttons do not react when pushed, an initialisation
must be performed:
1.
Disconnect the device from the socket
2.
Take out the batteries for a short time and then put them back in as described under the
point „charging the batteries“.
Removing the batteries reset the clock only. Other user settings are remain unchanged.
