page 3
2.2.
LCD Display
1. Display area for voltage, current, output, frequency, power factor and overload
2. Display area for time, operating time, costs, Euros, greenhouse gas emissions and energy
consumption
3. Graphical representation of energy consumption in the last 7 days or 7 months
3.
Using the device for the first time
When the device is delivered, the batteries are already inserted. Activate them by removing
the insulation strips in the battery compartment. To open the battery compartment, proceed
as described in the following section.
Changing the batteries:
1.
Pull the device out of the socket
2.
Push the two side catch springs of the battery compartment together at the same time and
pull the battery compartment out of the device
3.
Remove the empty batteries and dispose them of at a collection point for old batteries.
4.
Insert 2 new batteries (1.5 V button cells, type LR44/AG13) in the battery compartment.
When inserting the batteries, make sure that the polarity (+/-) is correct as shown on the
bottom of the battery compartment.
5.
Insert the battery compartment with the two contact springs in the device slots and push it
until it locks into place
Removing the batteries reset the clock only. Other user settings are remain unchanged.
The battery compartment can only be inserted in the device in one direction.
The battery compartment must be completely inserted before reactivating the device. If
you do not use the device for a prolonged period of time, take the batteries out of the device
to prevent them from becoming empty prematurely.
4.
Settings
To exclusively perform measurements (without a cost calculation), you can skip this section
and continue with point “4.6 Performing measurements”
1.
2.
3.
