Filter Cartridge Replacement Instructions
NOTE:
Before changing cartridge, turn off water supply. Place a bucket under the filter to catch the
small amount of water that will run out after the housing removal.
1.
Turn the mains water off and close the shutoff valve at filter head if installed.
2.
Relieve pressure in housing by pushing red vent button.
3.
Unscrew housing and remove old cartridge. Wash housing thoroughly with mild soap and water
and rinse thoroughly.
4.
Remove packaging from new cartridge and insert new cartridge and re-install housing. Be sure
cartridge is seated in the housing before tightening onto head.
5.
Use filter wrench to fully seat the cartridge. Tighten to make a water tight seal.
DO NOT OVERTIGHTEN OR THE O-RING MAY UNSEAT
6.
Turn on mains water and open shutoff valve at filter head. If any leaks appear tighten housing as
needed
7.
Flush system for five (5) minutes at nearest garden tap to activate the filter.
4
Содержание Whole Of House
Страница 1: ...Installation and Operation Manual...
