SteelMax S7, Руководство оператора

Страница: 15 / 20

OPERATION
(continued)
15
For best performance and to prevent overheating, empty the chip collector often
.
THE
S7
SAW IS EQUIPPED WITH A CHIP COLLECTOR COVER
(
STANDARD
)
TO CAPTURE METAL CHIPS
,
AND A DISCHARGE COVER TO
EXPEL WOOD CHIPS AS APPROPRIATE
. R
EFER TO THE DESCRIPTIONS BELOW
.
E M P T Y I N G T H E C H I P C O L L E C T O R
(
M E T A L C H I P C O L L E C T O R V E R S I O N
)
WARNING!
ALWAYS DISCONNECT THE SAW FROM POWER SOURCE BEFORE CHANGING BLADES
,
CLEARING CHIPS OR MAKING ADJUSTMENTS
.
1.
Loosen the two Chip Collector Cover Retaining screws (item# 21).
2.
Remove chip collector from the right side of saw. (item# 48)
3.
Empty chip collector by tipping the cover sideways and letting the chips and debris fall out. Clean all debris
from saw body.
4.
Install chip collector on saw and fasten securely by tightening thumbscrews.
WARNING!
FAILURE TO SECURE THE CHIP COLLECTOR COVER MAY RESULT IN UNCONTROLLED DISCHARGE OF CHIPS AND OPERATOR INJURY
.
ALWAYS
VERIFY PROPER INSTALLATION OF COVER AND CHECK FREQUENTLY
.
I N S T A L L I N G T H E D I S C H A R G E C H I P C O V E R
(
F O R W O O D C U T T I N G
)
WARNING!
ALWAYS DISCONNECT THE SAW FROM POWER SOURCE BEFORE
CHANGING BLADES
,
CLEARING CHIPS OR MAKING ADJUSTMENTS
.
1. Loosen the two Chip Collector Cover Retaining screws
(item# 21).
2.
Remove chip collector from the right side of saw. (item#
48)
3.The discharge cover (item# 101) is designed to be
used with a wood blade only. Install the discharge
cover in place of the chip collector cover. Wood
chips will be ejected out the discharge hole.
4. Install chip collector on saw and fasten
securely by tightening the thumbscrews.
S7 saw shown with discharge type
cover for wood use.