SM-S-7 XP Operator’s Manual
- 7 -
2017 Version 1.10
position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with
the retracting handle and make sure it moves freely and does not touch the blade or any other
part, in all angles and depths of cut.
•
Check the operation of the lower guard spring. If the guard and the spring are not operating
properly, they must be serviced before use. Lower guard may operate sluggishly due to
damaged parts, gummy deposits, or a build-up of debris.
•
Lower guard manually only for special cuts such as “plunge cuts” and “compound cuts.” Raise
lower guard by retracting handle. As soon blade enters the material, release the lower guard.
For all other sawing, the lower guard should operate automatically.
•
Always observe that the lower guard is covering the blade before placing saw down on bench
or floor. An unprotected, spinning blade will cause the saw to walk backwards, cutting
whatever is in its path. Be aware of the time it takes for the blade to stop after switch is released.
Additional Safety Instructions
•
Use clamps or another practical way to secure and support the workpiece to a stable platform.
Holding the work by hand or against your body leaves it unstable and may lead to loss of
control.
•
Keep your body positioned to either side of the blade, but not in line with the saw blade.
KICKBACK could cause the saw to jump backwards (see Causes and Operator Prevention of
Kickback and KICKBACK).
•
Make sure nothing interferes with the movement of the lower blade guard.
•
Make sure the saw is clean before use.
•
Stop using this saw and have it properly serviced if any unusual noise or abnormal operation
occurs.
•
Be sure all components are mounted properly and securely before using tool.
•
Wait until the motor has reached full speed before starting a cut.
•
Keep handles dry, clean and free of oil and grease. Hold the tool firmly with both hands when
in use.
•
Always be alert, especially during repetitive, monotonous operations. Always be sure of
position of your hands relative to the blade.
•
Stay clear of end pieces that may fall after cutting off. They may be sharp and/or heavy. Serious
personal injury may result.
•
Replace or repair damaged cords. Make sure your extension cord is in good condition. Use
only 3-wire (minimum 14 gauge) extension cords that have 3-prong grounding-type plugs and
3-pole receptacles that accept the tool’s plug.
