SM-S-7 XP Operator’s Manual
- 18 -
2017 Version 1.10
SAW MAINTENANCE
General Maintenance
Remove the power cord from the power supply before carrying out any adjustment, servicing or
maintenance on your Steelmax saw. Keep the machine clean and never use a saw blade that is
damaged or distorted. Replace the saw blade when it becomes dull. For service and replacement
pieces see the exploded parts diagram and parts list. Inspect the blade safety cover to assure that
it is in good condition and that it moves freely and smoothly. Never use the tool unless the safety
cover operates properly and it is in good operating condition.
After operation of the tool has been completed, make sure power plug has been removed from the
receptacle and store it in a secure place out of the reach of children. Periodically remove chips in
the dust cover and dust from the surface of the power tool with a damp cloth. Keep the tool away
from water or oil.
Replacing Carbon Motor Brushes
► Caution: Disconnect plug from power supply before servicing your saw.
Your saw’s carbon motor brushes must be replaced when
they are worn down to 6 mm or less in length from the
brush spring. Be sure brushes are clean and slide freely
in the brush holder. Always replace both carbon brushes
at the same time. Never repalce just one of the brushes.
Use only approved repalcement brushes. Use a flat-blade
screwdriver to remove the brush holder cap (A) and
remove the worn carbon brushes (B). Insert new carbon
brushes and re-secure the brush holder cap. Fig.21
