Rail Runner
Rail Runner Operator’s Manual
10
3. STARTUP AND OPERATION
3.1. Assembling the track
Connect magnetic units to the rail, and position it on the workpiece. Use the 4 mm
hex wrench to attach additional rails (
1
, Fig. 1), and then switch the levers of the
magnetic units to ‘I’ (
2
). This will clamp the track to the surface.
When working in PC/2G welding position, place the track so that the teeth of the
racks are directed downward.
Fig. 1.
Connecting the rails and clamping the magnetic units to the surface
Before attaching additional rails to a semi-flexible rail placed on a curve, use the
4 mm hex wrench to loosen the screws of the connecting plates (
1
, Fig. 2) and of
the racks (
2
). Next, attach the rails, clamp them with levers, and then tighten the
connecting plates. Place the rack adjustment tool (not included) into the hole (
3
), and
rotate the tool to the left (
4
) to remove the gap (
5
) between the racks. Then, tighten
the leftmost screw and the rightmost screw of each rack (
2
).
1
2
