OSC 8
OSC 8 Operator’s Manual
12
3.3. Operating
Use the knobs to set the required parameters from the table that follows. Then, set
the switch to MANUAL control to start oscillations. To stop oscillations, set the switch
to the middle position.
If the switch is set to EXTERNAL control, oscillations start when a 14
–24 V DC is
supplied
to
the
green
wire
(refer
to
chapter
3.2.1
for
the
diagram). To stop oscillations,
use an external START-STOP switch to disconnect the green wire.
Parameter
Value
Description
0
–100%
Oscillation width.
0
–100%
Oscillation speed.
0
–3 s
Oscillation dwell time in the
top position.
0
–3 s
Oscillation dwell time in the
bottom position.
Weld
end
Weld
start
1 /
EXTERNAL
MANUAL
