SteelMax Li'l Runner, Руководство оператора

Страница: 12 / 67

SM-WC-
LR Li’l Runner (HS)
Li’l Runner (HS) Operator’s Manual
12
To put the carriage closer to the workpiece, use the 4 mm hex wrench to remove
the roller assemblies. Next, install them at the other end of the guide arms, and then
swap the guide arms (Fig. 3).
Switch the magnet ON/OFF lever from left (‘O’) to right (‘I’). This will change the
clamping force from minimum to maximum. Loosen the levers to adjust the position
and angle of the torch. Use two knobs at the cross slide to precisely set the torch
position.
At heights, attach a fall arrester (not included) to a lug (Fig. 3) to prevent fall of
the carriage. This will avoid possible injury to the operator in case the carriage loses
the clamping. Do not stay below the carriage that is put at heights.
3.4. Operating
Set the power switch to ‘I’ to turn on the power. Then, the display comes on (
).
Next, if the unit of speed is set to centimeters per minute , shows. If the unit is
set to inches per minute, shows. Next, the carriage speed shows. Use the speed
knob to set the required speed. To control the torch through the carriage, set the arc
ignition switch to ‘I’.
If the arc ignition switch is set to ‘I’, the torch starts welding promptly
after you select a travel direction.
Use the travel direction switch to select a direction of travel. Then, the travel
starts with the speed that is shown. You can adjust the speed at any time.
To stop the travel, set the travel dir
ection switch to ‘O’.
After the work is finished, use the power switch to turn off the power. Then, un-
plug the carriage from the power source.