SM-WC-
LR Li’l Runner (HS)
Li’l Runner (HS) Operator’s Manual
11
3.3. Positioning at the worksite
Put the guide arms so that the carriage is in constant contact with the workpiece. You
can set them by a constant step (interval adjustment), or continuously after you swap
them (continuous adjustment). To set them correctly when the carriage moves to the
left, use the 4 mm hex wrench to loosen the screw that secures the right guide arm.
Next, move out the right arm about 10 mm
(0.4″) or one groove more than the
left arm (Fig. 3), and then tighten the screw again.
Fig. 3.
Correct positioning of the guide arms
You can install the roller assemblies at the
other end of the guide arms
Travel direction
Continuous adjustment
Interval adjustment
Swap the guide arms
to change between
methods of adjustment
Grooves
Moving out the right arm
by one groove
Lug for fall arrester
Содержание Li'l Runner
